| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-380-14&P
Section III. SUSPENSION SYSTEM MAINTENANCE PROCEDURES
Paragraph
Page
Number
ParagraphTitle
Number
Spring ............................................................................................................................. 5-6
SleeveBushing ................................................................................................................ 5-8
TrunnionTube ................................................................................................................ 5-10
Rubber Pad........ ............................................................................................................ 5-12
BrakeDrum ................................................................................................................... 5-13
ReliningBrakeShoes ...................................................................................................... 5-14
Kingpin .......................................................................................................................... 5-15
5-7. Spring
This task covers:
a. Removal
b. Cleaningandinspection
c. Installation
Initial Setup:
Tools/Test Equipment:
EquipmentConditions:
General Mechanic's Tool Kit (item 1, Appendix B)
Wheels removed (para. 3-4).
Automotive Shop Set (item 2, Appendix B)
Materials/Supplies:
Brush (item 15, Appendix E)
Personnel Required: Two
Drycleaningsolvent(item3,AppendixE)
a. Removal
1. Position semitrailer on level
surface with front end resting
on landing gear legs.
2. Extend leveling jack legs
enough to provide support
during removal and installation
procedures.
3. Place jack under each axle just
enough to support the weight
of the axle.
4. Support semitrailer with support
stands or blocking equipment.
5. Remove two nuts (1) and four washers (2) from each axle U-bolt (3). Remove axle U-bolts.
6. Remove eight nuts (8), washers (9) and screws (10) and remove two end caps (11).
|
||
|
||
