Custom Search
 
  
 


stall cable, insert bare end of cable through mount-
ing  bolt  and  socket  and  solder  terminal  to  end  of
cable.
Install
mounting
pad
over
mounting
bolt
(5) A s s e m b l y .
and against body base.
Loosely install 7/16-inch in-
ternal-teeth lockwasher and 7/16-inch hex nut on mount-
ing  bolt.  Position  new  lens  gasket  on  internal  shoul-
Place  lens
on
lens
gasket
and
secure
der  of  body.
with  lens  retaining  wire.
(6) Installation. Refer
to
75c.
d,
Clearance
Lights (fig. 70).
(1) R e m o v a l . Refer
to
(2) D i s a s s e m b l y . U n s c r e w t w o s c r e w s w h i c h s e c u r e c l e a r -
Lens is clipped to
ance light door and remove door.
door  by  two  speed  nuts  and  should  not  fall  out  on
removal of door. On blackout clearance lights, filter
is cemented to lens. To remove lens or filter assem-
bly,
pry
off
two
speed
nuts.
Remove
lamp
by
press-
ing  in,  twisting  about
one-eighth  turn  counterclock-
wise  and  withdrawing.
Unscrew  round-head  machine
Pull
rubber
grom-
screw next to socket and remove.
Bend
flat
sur-
met and socket assembly out of base.
face of grommet back to expose flange on socket and
draw  socket  out  of  grommet.  Remove  ground  strap
from under socket flange. Pull socket contact, spring,
and cable out of socket.
(3) C l e a n i n g . Clean
exterior
of
cover
with
mineral
spirits
paint
thinner
or
dry-cleaning
solvent.
If
necessary
to
clean interior of cover, lenses, filters, or socket, use
clean water and soap solution and dry thoroughly.
Inspect door for cracks, warp-
(4) I n s p e c t i o n a n d r e p a i r .
age,
cracked
or
broken
lenses,
filters
or  shields  and
Check grommet
attaching screws for serviceability.
for  distortion  and  pliability.  Should  it  appear  that
lens does not seat with some pressure on grommet,
replace  grommet.  Check  socket  assembly  to  make  sure
grommet, ground connector strap, socket, cable, and
connectors  are  in  good  condition  and  will  make  good
electrical and watertight connections when installed.
Make sure grommet is pliable and fits tightly to pre-
vent water from entering unit. Replace defective parts
at assembly. Individual parta of socket assembly may
be installed without complete disassembly. Moving parts
of socket can be installed by pulling cable out through
TAGO 1321B
159



 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business