| Tweet |
Custom Search
|
|
|
||
 frame
and
against
taillight
mounting
bracket
welded
to longitudinal beam of chassis frame and secure with
two
3/8
x
3/4
cap
screws
and
two
3/8-inch
lock-
washers.
Connect three taillight cable connectors.
Press
connectors into clips on mounting strap. Raise
hinged
shield
to
aline
hole
in
shield
with
hole
in
bracket welded to rear outrigger of body frame. Se-
cure shield with 3/8 x 1 cap
screw,
3/8-inch
lock-
washer, and 3/8-inch hex nut.
Position taillight behind open-
(2) S e m i t r a i l e r
M270A1.
ing in rear cross member of chassis frame and against
taillight mounting bracket welded to longitudinal beam
of chassis frame and secure with two 3/8 x 3/4 cap screws
Connect taillight cable
and
two
3/8-inch lockwashers.
Raise hinged shield to aline hole in shield
connectors.
with hole in bracket welded to rear outrigger of body
frame.
Secure shield with 3/8-inch lockwasher, 3/8
x 1 hex-head bolt, and 3/8inch hex nut.
73. Clearance Lights
Remove two oval-head screws which
a. Lamp Replacement.
Lift off cover and lens assem-
secure clearance light cover.
To
remove
lamp,
push
lamp
in,
turn
counterclockwise,
bly.
To
install
lamp,
insert
lamp
in
socket,
press
and withdraw.
Test lamp by turning on light
in, and turn clockwise to lock.
Position cover and lens assembly,
switch in towing vehicle.
Attach cover
making sure lens is seated on rubber grommet.
with two 1/4 x 3/4 ovel-head screws.
b. Removal.
Disconnect
cable
connector.
Note.
On
semitrailer
M270
M269,
remove
connector
from
clip
of
mounting
strap
before
disconnecting.
Remove
clearance
light
cover (a a b o v e ) .
Remove
four
square
nuts, lockwashers, and roundhead screws securing light to outer
Remove
light
and
gasket.
rail of body frame.
c. Instrallation.
If
light gasket is damaged, install a new
Insert
connecting cable through opening in outer rail
gasket.
of body frame and position clearance light.
Secure light to
rail with four No. 10 x 2 roundhead screws, No. 10 lockwash-
Install
clearance
light
cover
(a
ers, and No. 10 hex nuts.
above).
If clearance light is being installed on semitrailer
M270 or M269, it will be necessary to press light cable con-
nector into clip of mounting strap.
74. Blackout Stoplight
a. Lamp Replacement.
Remove two oval-head screws which
TAGO 1321B
111
|
||
|
||
