| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-331-14&P
0071 00
FRONT AND REAR AXLE REPLACEMENT-continued
FRONT AND REAR AXLE REMOVAL-continued
1. Raise semitrailer and position jackstand under center axle not being removed.
2. Disconnect ABS sensor cables as necessary.
3. Remove eight flange nuts (nut, plain, extended washer) (7), washers (2), screws (1), two axle
end caps (9), and rubber strips (8) from axle (3) and equalizing beam (6). Discard flange nuts
and rubber strips.
4. Remove axle (2), two axle adapters (3), and rubber pads (5) from equalizing beam (6).
1
2
9
8
3
4
5
6
7
Figure 1. Axle
FRONT AND REAR AXLE INSTALLATION
1. Position two rubber pads (5), axle adapters (4), and axle (3) on equalizing beam (6).
2. Position two new rubber strips (8) and axle end caps (9) on axle (3). Install eight screws (1),
washers (2), and new flange nuts (nut, plain, extended washer) (7).
3. Torque all fasteners per WP 0019 00-3.
0071 00-2
|
||
|
||
