| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-329-14&P
CURBSIDE LANDING LEG REPLACEMENT
THIS WP COVERS:
Removal, Installation, Follow-On Tasks
INITIAL SETUP:
Maintenance Level
Tools and Special Tools
Organizational
Tool kit, general mechanic's (item 4, WP 0156 00)
Jack stands (item 3, WP 0156 00)
Materials/Parts
Lifting device (item 1, WP 0156 00)
Self-locking nuts (10) (item 97, WP 0160 00)
Equipment Conditions
Self-locking nuts (2) (item 132, WP 0160 00)
Semitrailer grounded (refer to WP 0007 00)
Personnel Required
Semitrailer fuel tank drained (refer to WP 0007 00)
Two
Batteries removed (refer to WP 0053 00)
Optic socket box mounting bracket disconnected
References
(refer to WP 0048 00)
REMOVAL
NOTE
Landing gear legs should be raised 6 inches (15.2 cm)
off the ground prior to performing this procedure.
Semitrailer must be on jack stands or connected to
a prime mover prior to performing this procedure.
1.
Remove self-locking nut (2), two washers (3), and bolt (4) from leg support bracket (1). Discard
self-locking nut.
0081 00-1
|
||
|
||
