TM 10-6640-215-13
5-5. REMOVE/INSTALL WATER PUMP - continued.
i.
Remove pipe fittings from pump and retain for reuse.
INSTALLATION
Install Water Pump. See figure 5-1.
a.
Apply teflon tape to male fittings. Be sure to wrap tape in same direction as pipe thread.
b.
Install pipe fittings on pump.
c.
Install water pump on foundation with four bolts, flat washers, lockwashers, and nuts.
d.
Connect hose to drain petcock.
e.
Connect union on suction supply line to water tank.
f.
Connect union on suction supply line to water filter.
g.
Connect union on pump discharge line to the surge tank.
h.
Connect pump motor electrical leads to motor connection box. Remove tags.
i.
Set A15CB8 at POWER PANEL No. 2 to ON.
j.
Set switch on WATER PUMP controller to ON.
k.
Prepare and operate water system using internal water tank as source in accordance with procedures listed
in paragraph 2-8.
I.
Inspect for leaks and check for proper operation.
Figure 5-1. Water Pump Removal and Installation
5-3
|
|
