| Tweet |
Custom Search
|
|
|
||
 plate. Aline holes in socket and wiring assembly and
body and install six No. 8 x 3/8 round-head screws.
If lamps were removed, press each into socket and
turn clockwise to lock in place. Position
new
gasket
in groove in door and install door.
(6) Installation.
Refer to paragraph 71c.
b.
(1) R e m o v a l . Refer to paragraph
(2) D i s a s s e m b l y .
Remove
two
oval-head
screws
securing
door
assembly
to
body.
Remove door assembly and
door gasket from body. Remove door gasket from door.
Remove two shouldered screws and plain washers se-
curing socket and wiring assembly to body. Pull socket
and wiring assembly from body.
Remove two grom-
mets from socket plate.
(3) C l e a n i n g . Clean exterior of body and door with min-
eral spirits paint thinner or dry-cleaning solvent. If
necessary to clean interior of body or socket plate with
attached parts, use clean water and soap solution. Dry
thoroughly.
(4) I n s p e c t i o n a n d r e p a i r . I n s p e c t
door
assembly
for
cracks,
warpage, cracked or broken lens, or evidence of leak-
age around lens gasket.
Note. It is not practical to attempt replacing lens or lens gasket
in door assembly since these parts are clinched in place to make
a watertight seal.
Inspect
body
for
cracks
or
evidence
of
leakage.
Re-
place body if damaged. Check socket and wiring as-
sembly to make sure grommets, socket, strap, cable,
and connector are in good condition and will make
good electrical and watertight connections when in-
Pay particular attention to body grommet at
stalled.
rear of socket and wiring assembly to make sure cable
is cemented securely to grommet and grommet wi11
make watertight seal in body when installed. Rcplace
defective
parts
of
assembly.
(5) A s s e m b l y . I n s t a l l g r o m m e t i n n o t c h e s o n s i d e s o f s o c k e t
and wiring assembly. Position socket and wiring as-
sembly
in
body
by
pressing
assembly
into
body
until
body grommet at rear of
assembly seats
tightly in
Aline holes in
grommets
opening at rear of body.
installed in socket and wiring assembly with mount-
ing holes in body and secure with two plain washers
Install a new door gasket in
and shouldered screws.
TAGO 1321B
156
|
||
|
||
