| Tweet |
Custom Search
|
|
|
||
 Make
certain
ball
with
bushing
assembly
material.
(A-2)
is
securely
mounted
in
rod.
(2)
Remove burs or hand chase damaged threads with
fine file. If damage to thread cannot be corrected, if
rubber
is
hard
or
cracked,
or
if
ball,
with
bushing,
assembly is loose in rod, install new ball, with bushing,
assembly. To install new assembly, mount rod in ar-
bor press and with remover and replacer 7950122 (fig.
press
out
ball,
with
bushing,
assembly.
Position
new ball, with bushing, assembly (A-2) and press into
rod with remover and replacer 7950122 (fig. 58).
Figure 58.
Installing ball, with bushinq, in torque rod using remover and
replacer 7950122.
d.
Installation.
(1) Insert threaded portion of ball (A-1), at one end of
torque rod (A-1), in hole in torque rod bracket (G).
Using rod as lever, bend ball out of alinement so
threaded portion of ball at other end is close to hole
in bracket extending from tube with brackets assem-
bly (fig. 9).
(2) With crowbar or cold chisel, bend ball out of aline-
ment to enter hole.
Use care not to damage threads,
TAGO 1321B
131
|
||
|
||
