| Tweet |
Custom Search
|
|
|
||
 RA PD 370876
Special tools for organizational maintenance.
surrounding
surfaces
clean
before
and
after
lubricant
is applied.
(2)
A -inch red circle should be
painted
around
each
lubricating fitting and oil hole.
(3) Clean and lubricate unsealed bearings as follows:
(a)
Wash all of the lubricant out of the bearings and
from the inside of hubs with mineral spirits paint
thinner, and dry the parts thoroughly.
C a u t i o n : Bearings must not be dried or spun with
compressed air. See TM 37-265 for care and main-
tenance of bearings.
Pack
the
bearings
by
hand
or
with
a
mechanical
(b)
packer, introducing the lubricant carefully between
Do not smear grease only on the out-
the rollers.
side of the bearings and expect it to work in. Great
care must be exercised to insure that dirt, grit, lint,
or
other
contaminants are not introduced into the
b e a r i n g s . I f t h e bearings are not to be installed
i m m e d i a t e l y a f t e r repacking, they should be wrapped
in clean oilproof paper to protect them from con-
taminants.
58
TAGO 1321B
|
||
|
||
