Tweet |
Custom Search
|
|
|
||
clearance lights (figs. 4 and 5) one on each side, are
located toward the rear of the vehicle. Two red service
clearance lights, one on each side, are located toward
the rear of the vehicle, directly below the red blackout
clearance lights. Four amber blackout clearance lights,
two on each side, are located at the center and toward the
Four amber service clearance
front of the vehicle.
lights, two on each side, are located at the center and
toward
the
front
of
the
vehicle.
Two red blackout clearance lights
(2) S e m i t r a i l e r M 2 6 9 .
Two red service clearance lights, one
of the vehicle.
on each side, are located toward the rear of the ve-
hicle, directly below the red blackout clearance lights.
Two amber blackout clearance lights, one on each side,
Two
are located towards the front of the vehicle.
amber service clearance lights, one on each side, are
located towards the front of the vehicle, directly below
the amber blackout clearance lights.
h. Intervehicular Cable Receptacles and Sockets.
A 24-volt intervehicular
recep-
(1) S e m i t r a i l e r M 2 7 0 A 1 .
tacle
assembly
located
at
the
front
end
or
nose of the vehicle, is attached
to
the
front
cross
member of the chassis frame.
(2) S e m i t r a i l e r s M 2 7 0 a n d M 2 6 9 . A 2 4 - v o l t i n t e r v e h i c u l a r
receptacle
assembly
(fig.
28),
12-volt
socket
assembly,
and 6-volt socket assembly, located at the front end or
nose of the vehicle, are attached to the front cross
member of the chassis frame.
6.
Chassis Frame and Body Frame
a. T h e c h a s s i s f r a m e i s o f w e l d e d c o n s t r u c t i o n w i t h d r o p -
frame i-section, longitudinal beams, and intermediate cross mem-
bers.
Raised
and
extended
sections
of
beams
are
welded
to
the forward ends of the longitudinal beams to form the front
end or nose of "the vehicle. These beams are strengthened with
cross
members,
plates,
and
reinforcements.
Mounting
brackets
for the tandem axle spring suspension are riveted to the outer
side and underside of the longitudinal beams.
structural steel side rails, pressed steel cross members, sup-
ports, outriggers, and short cross members. The short cross
members and outriggers are used to provide support for the
plates covering the wheel housing openings of the body frame.
TACO 1321B
16
|
||