| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-380-14&P
4-64. Doors
This task covers
a. Removal
b. Cleaning
c. Inspection and repair
d. Installation
Initial Setup:
Tools/Test Equipment:
EquipmentConditions:
General mechanic's tool kit (item 01, Appendix B)
Materials/Supplies:
Drycleaningsolvent(item3,AppendixE)
Brush (item 15, Appendix E)
a. Removal
1. Remove setscrews (2) securing three hinge pins (1).
2. Drive out hinge pins (1). Remove two flat washers (3),
located between each hinge butt (5) and hinge strap (4).
Remove door.
b. Cleaning
1. Remove dirt and mud with steam or water and brush
(item 15, Appendix E).
WARNING
Dry cleaning solvent (P-D-680) is toxic and flammable. Avoid prolonged breathing of vapors.
Avoid skin contact. Use only in a well-ventilated area. Keep away from open flame. Flash point
of solvent is 138o F (50o C).
2. Remove grease and oil with dry cleaning solvent (item 3, Appendix E). Dry thoroughly.
c. Inspection and repair
1. Inspect door for cracks, dents or other damage. Repair or replace parts as required.
2. Visually inspect all hardware for defects. Replace defective parts.
3. Weld cracked or fractured items (refer to TM 9-237).
|
||
|
||
