Toggle Switch and Backwall Receptacle Replacement (M129A4 Only)

Custom Search

Back
Power Inlet (M129A4 Only)

Up
TM-9-2330-380-14-P Semitrailer Van: Electronic Tactical 12-Ton 4-Wheel XM1063 (NSN 2330-01-224-9244) and M129A4 (NSN 2330-01-372-5642) Manual

Fan Replacement (M129A4 Only)

TM 9-2330-380-14&P

4-32. Toggle Switch and Backwall Receptacle Replacement (M129A4 Only)

This task covers:

a. Removal

b. Installation

Initial Setup:

Tools/Test Equipment:

EquipmentConditions:

General mechanic's tool kit (item 01, Appendix B)

Power source disconnected.

WARNING

Make sure all electrical power is disconnected before performing any maintenance on the electrical

system. Serious injury or death may result if proper precautions are not taken.

NOTE

All toggle switches are removed/installed in the same manner. Bottom toggle switch is shown.

a. Removal

1. Remove screw (2) and wall plate (1).

2. Remove two screws (3) from connector (4).

3. Tag and disconnect wires. Remove connector (4).

4. Remove two screws (5) and electrical cover (6).

5. Remove two screws (7) from toggle switch (8).

6. Tag and disconnect wires. Remove toggle switch (8).

b. Installation

1. Connect wires. Position connector (4) and secure with

two screws (3).

2. Install electrical wall plate (1) and screw (2).

3. Connect wires. Position toggle switch (8) and secure with two screws (7).

4. Install electrical cover (6) and two screws (5).

Follow-on maintenance: None