| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-380-14&P
1-7. Location and Description of Major Components (cont'd)
l.
Suspension System
Consists of a single point, two spring tandem axle
suspension (1).
Each spring contains three leaves.
Each end of spring rests on rubber pads in
spring box.
m. Dolly Electrical System
Wiring harnesses and wiring assemblies are located
along the rail of the dolly frame. They extend from
the electrical inlet receptacles on the front of the
resistor box to running lights.
1. Light, turn and marker
Two lights (1), one installed at each end of
the dolly frame.
2. Reflector, red
Two red reflectors (2), located just
in-boar of the two turn and marker lights.
3. Light stop and turn
Two lights (3) located just in-board of
each of the two reflectors.
Incandescent
Lights Shown
4. Light, blackout stop and right hand turn
and tail
One light (4) installed on right rear dolly frame between the two right lights and above the
reflector.
5. Light, blackout stop and left hand turn and tail
One light (5) installed on left rear dolly frame between the two left lights and above the reflector.
6. Light, clearance, red
Two lights (6), one at each bottom rear side of dolly frame.
n. Splash Guard
A splash guard (7) is installed at rear of each rear wheel.
|
||
|
||
