| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-331-14&P
SCOPE
This work package lists standard torque values, as shown in Table 11, and provides general
information for applying torque. Special torque values and tightening sequences are indicated in the
maintenance procedures for applicable components.
GENERAL
a. Always use the torque values listed in Table 11 when the maintenance procedure does not
give a specific torque value.
b. Unless otherwise indicated, standard torque tolerance shall be + 10%.
c. Torque values listed are based on clean, dry threads. Reduce torque by 10% when engine oil
is used as a lubricant, Reduce torque by 20% if new plated capscrews are used.
d. Capscrews threaded into aluminum may require reductions in torque of 30% or more of Grade 5
capscrews torque. Capscrew threaded into aluminum must also attain two capscrew diameters
of thread engagement.
|
||
|
||
