| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-330-14&P
CURBSIDE LANDING LEG REPLACEMENT
THIS WP COVERS:
Removal, Installation, Follow-On Tasks
INITIAL SETUP:
Maintenance Level
Tools and Special Tools
Organizational
Tool kit, general mechanic's (item 4, WP 0171 00)
Jack stands (item 3, WP 0171 00)
Lifting device (item 1, WP 0171 00)
Materials/Parts
Self-locking nuts (10) (item 97, WP 0175 00)
Self-locking nuts (2) (item 132, WP 0175 00)
Equipment Conditions
Semitrailer grounded (refer to WP 0007 00)
Semitrailer fuel tank drained (refer to WP 0007 00)
Personnel Required
Two
Batteries removed (refer to WP 0055 00)
Optic socket box mounting bracket disconnected
References
(refer to WP 0050 00)
REMOVAL
NOTE
Landing gear legs should be raised 6 inches (15.2 cm) off the
ground prior to performing this procedure.
Semitrailer must be on jack stands or connected to a prime
mover prior to performing this procedure.
1.
Remove self-locking nut (2), two washers (3), and bolt (4) from leg support bracket (1). Discard
self-locking nut.
0084 00-1
|
||
|
||
