| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-330-14&P
ENGINE TROUBLESHOOTING--Continued
0023 00
Table 1. Troubleshooting Procedures--Continued
TEST OR INSPECTION
CORRECTIVE ACTION
MALFUNCTION
2.
ENGINE TURNS OVER
4.
Check condition of fuel
If fuel filter is clogged, replace
filter.
fuel filter (refer to WP 0109 00).
BUT FAILS TO START--
Verify problem is solved. If
Continued
condition of fuel filter was okay,
go to step 5.
5.
Check engine for high
If engine is hot, allow 35
operating temperature.
minutes to cool before
attempting restart. Verify problem
is solved. If engine will not start
after cooling, go to step 6.
6.
Check for restricted air
If air passages are restricted,
passages or red band in
clear restricted passages and/or
air restriction indicator
replace air element (refer to WP
(refer to WP 0112 00).
Verify problem is solved. If air
passages are okay, go to step 7.
7.
Check for defective glow
If glow plugs are defective,
plugs.
replace glow plugs (refer to WP
solved. If glow plugs were okay,
notify Direct Support
maintenance that further
troubleshooting is required.
1.
Check to see if engine oil
Drain oil and refill with proper
3.
ENGINE IS HARD TO
is proper grade for ambient grade oil (refer to WP 0044 00).
START OR HAS LOW
temperature.
Verify problem is solved. If oil
POWER
was okay, go to step 2.
2.
Check for dirty,
If fuel is dirty, drain and remove
contaminated, or wrong
fuel tank (refer to WP 0108 00)
grade of fuel.
and fuel lines and replace and
refill tank with clean fuel.
Replace fuel filter (refer to WP
solved. If fuel was okay, go to
step 3.
|
||
|
||
