TM 9-2330-326-14&P
C-4. LUBRICATION CHART AND DIAGRAM (Cont.)
Clean fittings before lubrication using cleaning compound. Dry before lubricating.
The dotted leader lines indicate lubrication is required on both sides of the equipment.
Re-lubricate after washing or fording as necessary.
LUBRICATION
INTERVAL
LUBRICATION TYPE/SPECIAL
POINTS
INSTRUCTIONS/MAINTENANCE
LEVEL ( )
ABS Sensor Body and
When replaced or removed from
GAA, light coat on sensor body,
Spring Clip
clip
wipe off excess. When removed
from spring clip, clean off old grease
and apply a new light coat. (O)
Automatic Slack
Semiannually or every 6,000 miles
GAA, zerk fittings. (O)
Adjuster
(9,656 km)
Semiannually or every 6,000 miles
OE/HDO-10, clevis pins, oil can
(9,656 km)
points. (O)
Stowage Box and
Monthly or every 1,000 miles
OE/HDO-10, hinge/latch, oil can
Padlocks
(1,609 km)
points. (C)
Twist Locks (8)
Monthly or every 1,000 miles
Clean, oil can point
(1,609 km)
OE/HDO-10 for housing. (C)
GAA, zerk fittings (O)
Tiedown Rings
Monthly or every 1,000 miles
OE/HDO-10, oil can points. (C)
(1,609 km)
Cargo (36)
Ammo (4)
Lift/Tie-down (12)
Landing Gear Shoes,
Monthly or every 1,000 miles
OE/HDO-10, oil can points. (C)
Swing Pins, and Crank
(1,609 km)
Handle
All Receptacle Pins
When Taken Apart/Replaced
Dielectric Grease. Clean and Apply
and Connectors
a Thin Coat. (O)
C-3