| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-326-14&P
Table 4-1. Unit PMCS (Cont.)
ITEM
INTERVAL
ITEM TO
EQUIPMENT NOT
NO.
M
S
A
T
MI
CHECK/
PROCEDURE
READY/
SERVICE
AVAILABLE IF:
M
S
A
T
MI
Apply a coat of UV wood or linseed oil
Wood Decking
Board(s) are
16
Every
protector to upper and lower deck surfaces.
Corrosion
broken or
?
12,000
missing.
17
M
S
A
T
MI
Wheel
WARNING
Every
Bearings
? 36,000
Do not use air pressure or a steel
bristle brush to clean cones and
rollers. Use kerosene or diesel fuel
to clean bearings. Do not use
gasoline. Do not rotate bearings
using compressed air, as this will
damage the polished surfaces.
Bearing failure can cause injury.
At triennial brake inspection/service
all brake wheel end components
must be cleaned and inspected for
wear/damage. Inspect all linings,
springs, pins, rollers, clips and
bushings on each axle end. Make
sure seals show no signs of leakage
on axle, spider or wheels. Use all
components of replacement kits and
balance repairs on both axle ends.
Failure to comply can cause injury
to personnel and damage to the
equipment.
Worn or
Clean, inspect, and repack inner and outer
damaged.
cones and rollers. Replace if damaged or
worn.
18
M
S
A
T
MI
Seals
Check condition of seals for indicators of
Seal is damaged,
Every
problems. When seal is removed, it should
worn, or leaking.
? 36,000
be replaced. Use correct seal installation
tool to drive/seat seal and never re-use a
seal.
19
M
S
A
T
MI
Spindle
Check spindle for damaged threads and
Spindle is
Every
surface area for rust/pitting. Notify Direct
damaged.
? 36,000
Support maintenance.
4-11
|
||
|
||
