| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-326-14&P
Table 4-1. Unit PMCS (Cont.)
ITEM
INTERVAL
ITEM TO
EQUIPMENT NOT
NO.
M
S
A
T
MI
CHECK/
PROCEDURE
READY/
SERVICE
AVAILABLE IF:
13
M
S
A
T
MI
Studs and
a. Check studs and flange nuts for
Studs or flange nuts
Every
Flange nuts
damage.
are damaged or
?
6,000
loose.
NOTE
All flange nuts and studs have
right-hand threads,
b.
Flange nut torque:
Torque flange nuts to 50 lb-ft (67.8 Nm) and
then tighten to 450500 lb-ft (610678 Nm)
using DRY torque.
c. Torquing sequence is as follows:
Using DRY torque for flange nuts and
studs, facing wheel, clockwise
sequence starting at top (see
Appendix H-57).
CAUTION
Do not use air or electric tools
to adjust ASAs.
Initial adjusting procedures
start with measurements not
tear-down.
14
M
S
A
T
MI
Automatic
Check for any binding, broken, worn or loose
Binding, wear,
Every
Slack
parts, missing hardware, evidence of an out-of-
loose parts,
?
6,000
Adjusters
adjustment condition, worn clutch, and release
missing hardware,
(ASAs)
action.
out-of-adjustment
conditions are
evident.
15
M
S
A
T
MI
Axles
Check axles for proper alignment (refer to
Axles are not in
Every
alignment.
?
12,000
page 21-25). If suspension is damaged, notify
Direct Support maintenance.
4-10
|
||
|
||
