Custom Search
 
  
 


TM 10-6640-238-13 4-111 4-45.    KINEMATIC VISCOSITY BATH. This task consists of: a. Remove b. Install INITIAL SET-UP Tools Required General Mechanics Tool Kit, (Appendix B, Section III, Item 1) General Safety Instructions WARNING ELECTRICAL SHOCK Before  performing  any  maintenance  actions  on  electrical  equipment,  ensure  all electrical power has been turned off.  Failure to comply with this warning may result in serious injury or death. REMOVE Remove Kinematic Viscosity Baths.  See Figure 4-41. a. Unplug controller (1) for viscosity bath (2) from wall receptacle. b. Disconnect strap (3) and remove top bracket (4) from viscosity bath (2). c. Lift controller (1) from viscosity bath (2). d. Loosen four captive wing bolts (5) and remove two hold down brackets (6). e. Remove viscosity bath (2). INSTALL Install Kinematic Viscosity Baths.  See Figure 4-41. a. Install viscosity bath (2) in place on foundation. b. Install two hold down brackets (6) and secure with four captive wing bolts (5). c. Lower controller (1) into viscosity bath (2). d. Place top bracket (4) with strap (3) in position on viscosity bath (2) and secure strap. e. Plug controller (1) for viscosity bath (2) into wall receptacle. f. Verify viscosity bath operation. NOTE For component removal refer to commercial manual.


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business