TM 10-6640-215-13
5-8. REMOVE/INSTALL SURGE TANK.
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP:
Tools required
General Mechanics Tool Kit, (Appendix B, Section III, Item 2)
Material Required
Teflon Tape, (Appendix E, Section II, Item 157)
Equipment Condition
Water pump turned off.
REMOVAL
Remove Surge Tank. See figure 5-4.
a.
Remove cap and depress air valve stem to bleed pressure from surge tank.
b. '
Unscrew surge tank from threaded fitting.
c.
Remove surge tank.
INSTALLATION
Install Surge Tank. See figure 5-4.
a.
Apply teflon tape to male fittings. Be sure to wrap tape in same direction as pipe thread.
b.
Screw surge tank onto threaded fitting.
c.
Prepare and operate water system using internal water tank as source in accordance with procedures listed
in paragraph 2-8.
d. Inspect for leaks and check for proper operation.
Figure 5-4. Surge Tank Removal and Installation
5-7
|
|
