TM 10-6640-215-13
SECTION IV. ADMINISTRATIVE STORAGE
Alphabetical Index
Paragraph Title
Paragraph
Introduction ........................................ ...................................................................................................
3-11
Prior to Placing Unit in Storage ................................................ .............................................................
3-11b.
Storage Length and Readiness ..............................................................................................................
3-11a.
Storage Site Selection ...........................................................................................................................
3-11c.
3-11. INTRODUCTION.
This section contains information on administrative storage procedures. If additional information is required, refer to
TM 740-90-1.
a.
Storage Length and Readiness. Placement of equipment in administrative storage should be for short periods of
time (1 to 45 days) when a shortage of maintenance efforts exists. Items should be in mission readiness within 24
hours or within the time factors as determined by the directing authority. During the storage period, appropriate
maintenance records will be kept.
b.
Prior to Placing Unit in Storage. Before placing equipment in administrative storage, current maintenance services
and Preventive Maintenance Checks and Services (PMCS) evaluations should be completed, shortcomings and
deficiencies should be corrected, and all Modification Work Orders (MWOs) I should be applied. Water lines shall
be drained before storage. Drain water from piping as follows:
NOTE
Draining may be accomplished quickly by applying slight air pressure to supply and
return lines.
1. Remove camlock.
2. Open tank drain.
3. Open system drain.
4. Open spigot in sink.
c.
Storage Site Selection. Inside storage is preferred for items selected for administrative storage. If inside storage
is not available, the sites selected should provide required protection from the elements and allow access for visual
inspection when applicable.
Change 2 3-29/(3-30 blank)
|
|
