TM 10-6640-215-13
SECTION III. OPERATOR MAINTENANCE PROCEDURES
Alphabetical Index
Maintenance Item
Paragraph
Aneroid Barometer .................................................. ...........................................................................................
3-8
Electric Still ........................................................................................................................................................
3-9
Fluorescent Light Fixture.....................................................................................................................................
3-4
Introduction ........................................................... ............................................................................................
3-3
Overpack Box .......................................................... ..........................................................................................
3-7
Purge Intake Door Filters ................................................ ...................................................................................
3-5
Pressure Recording Gage .................................................... ..............................................................................
3-6
Typewriter Ribbon ...................................................... ........................................................................................
3-10
3-3. INTRODUCTION .
This section contains instructions covering maintenance functions for the operator on the Petroleum Laboratory.
Personnel required are listed only if the task requires more than one.
After completing each maintenance procedure, perform operational check to be sure that equipment is properly
functioning.
3-4. REMOVE/INSTALL FLUORESCENT LIGHT FIXTURE LAMP AND STARTER.
This task consists of:
a.
Removal
b
Installation
INITIAL SET-UP:
Tools Required
General Mechanics Tool Kit, (Appendix B, Section III, Item 2)
Equipment Conditions
Place appropriate circuit breaker in the OFF position.
General Safety Instructions
WARNING
ELECTRICAL SHOCK
Before performing any maintenance actions on electrical equipment, ensure all
electrical power has been turned off. Death or serious injury may occur from
failure to do this.
REMOVAL
1.
Remove Fluorescent Lamp. See figure 3-1.
a.
Loosen four captive screws holding diffuser to lamp fixture. Carefully remove diffuser
from light fixture.
3-15
|
|
