TM 10-6640-215-13 Table 3-2.  Troubleshooting - continued MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION 34. MANOMETER GIVES INACCURATE (HIGH/LOW) PRESSURE READING - (Cont) Step 2. Check for leaks or obstructions. a. Make applicable corrections. b. If manometer still gives inaccurate readings, notify unit maintenance. 35. KINEMATIC VISCOSITY BATH DOES NOT OPERATE. Step 1. Check that unit's power cord is plugged into convenience outlet for viscosity bath. Step 2. Check that line switch is ON. Step 3. Check and reset circuit breaker A1CB5 located in MAIN POWER PANEL. If bath still fails to operate, notify unit maintenance. 36. CENTRIFUGE FAILS TO OPERATE (RUN PUSHBUTTON ON, LAMP OUT). Step 1. Ensure that unit's power cord is plugged into convenience outlet J11. Step 2. Check position of line switch. Place line switch ON. Step 3. Check and reset circuit breaker AICB8 located in MAIN POWER PANEL. If centrifuge still fails to operate, notify unit maintenance. 37. DISTILLATION TEST APPARATUS FAILS TO OPERATE. Step 1. Ensure unit's power cord is plugged into convenience outlet for distillation unit. Step 2. Check position of line switch. Place line switch ON. Step 3. Check and reset circuit breaker AICB7 located in MAIN POWER PANEL. If distillation test apparatus still fails to operate, notify unit maintenance. 3-12