TM 10-6640-215-13
CHAPTER 3
OPERATOR MAINTENANCE
Section I.
Lubrication Instructions
Section II.
Operator Troubleshooting Procedures
Section III.
Operator Maintenance Procedures
Section IV.
Administrative Storage
SECTION I. LUBRICATION INSTRUCTIONS
Lubrication instructions for the basic semi-trailers' doors, leveling jacks, landing gear, etc., can be found in Chapter 3 of
TM 9-2330-362-14&P. For lubrication instructions concerning the ECUs, refer to TM 5-4120-317-14. Lubrication
requirements for other equipment used in the Petroleum Laboratory are contained in their respective TMs.
SECTION II. OPERATOR TROUBLESHOOTING PROCEDURES
Alphabetical Index
Paragraph Title
Paragraph
Introduction .................................................................................................................................................
3-1
Troubleshooting ..........................................................................................................................................
3-2
3-1.
INTRODUCTION.
This sections contains operator troubleshooting information and procedures for locating and correcting common
malfunctions which may develop in the laboratory.
Table 3-1 lists common malfunctions which you may find during operation or maintenance of the Petroleum Laboratory
or its components. You should perform the test/inspection and corrective actions in the order listed.
This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective actions. If a
malfunction is not listed or is not corrected by listed corrective actions, notify your supervisor.
3-2.
TROUBLESHOOTING.
Use the symptom index in table 3-1 for quick access to troubleshooting procedures in Table 3-2.
3-1
|
|