TM 10-3930-665-13&P
Section III OPERATION IN USUAL CONDITIONS
2-4 SET-UP
Before using the conveyor, the operator should ensure that the area in which the conveyor will be used is separated from
personnel traffic. It is also important to check that the materiel to be moved is within the weight and load restrictions of the
machine. Once the above conditions are met, and the area has been cleared, setup may begin.
a.
Roll the conveyor into position.
b.
Lock casters.
c.
Adjust the lifter to allow the correct angle.
CAUTION:
ENSURE LOCKING PINS ARE REMOVED BEFORE RAISING OR LOWERING THE
CONVEYOR. FAILURE TO DO SO MAY CAUSE EQUIPMENT DAMAGE.
d.
Check that the movement of the belt is not restricted.
e.
Plug conveyor in.
f.
Adjust belt direction switch.
g.
Press start switch.
CAUTION:
IF AT ANY TIME THE CONVEYOR BELT BECOMES JAMMED, OR OTHERWISE
IMMOBILIZED,
IMMEDIATELY
STOP
THE
MACHINE
AND
FOLLOW
THE
TROUBLESHOOTING PROCEDURES FOUND IN CHAPTER 3. FAILURE TO DO SO
MAY CAUSE INJURY TO PERSONNEL OR INJURY TO EQUIPMENT.
2-3
|
|
