| Tweet |
Custom Search
|
|
|
||
 TB 9-2330-381-14-1
(ap) Engage AUXILIARY WINCH KICKOUT by lifting and rotating AUXILIARY WINCH KICKOUT lever
(10) CW.
(aq) Disengage DRIVERS SIDE WINCH KICKOUT (19) switch by pulling switch.
WARNING
Do not allow auxiliary winch cable to cross itself or knot up on winch or serious
injury to personnel may occur.
(ar) With one person to operate winch controls and a second person to ensure that winch cable devises
do not hang up on platform, push down on AUXILIARY WINCH lever (30) to pull driver's side winch
cable (35) to auxiliary snatch block (12).
(as) If auxiliary winch cable (13) does not pull driver's side winch cable (35), push ENGINE SPEED
CONTROL switch (31) to HIGH ENGINE IDLE.
(at) Momentarily push ENGINE SPEED CONTROL switch (32) to lock engine speed at hi gh engine idle
(approximately 1,500 rpm) and then release switch.
(au) When driver's side winch cable (35) reaches front of platform, release AUXILIARY WINCH lever (30).
(av) Route driver's side winch cable (35) through gooseneck cable guide (33).
(aw) Push down on AUXILIARY WINCH lever (30) and continue to pull driver's side winch cable (35) to
auxiliary snatch block (12).
(ax) Release AUXILIARY WINCH lever (30) when driver's side winch cable (35) is approximately 12
inches (30 cm) from auxiliary snatch block (12).
(ay) Spotter must continue to pull driver's side winch cable (35) until winch cable has enough slack that it
touches ground.
(az) Remove cotter pin (27) and shouldered pin (28) from auxiliary winch cable clevis (29).
(ba) Separate auxiliary winch cable (13) from driver's side winch cable (35).
(bb) Lay driver's side winch cable (35) on ground at rear of payload.
(bc) Install shouldered pin (28) and cotter pin (27) into auxiliary winch cable clevis (29).
2-61
|
||
|
||
