| Tweet |
Custom Search
|
|
|
||
 TB 9-2330-381-14-1
2-3.
DUAL WINCH LOADING AND UNLOADING DISABLED PAYLOAD WITH MINE CLEARING BLADE
ATTACHED (CONT)
(y) When passenger side winch cable (23) reaches front of platform, release AUXILIARY WINCH lever
(30).
(z) Route passenger side winch cable (23) through gooseneck cable guide (33).
(aa) Push down on AUXILIARY WINCH lever (30) and continue to pull passenger side winch cable (23) to
auxiliary snatch block (12).
(ab) Release AUXILIARY WINCH lever (30) when passenger side winc h cable (23) is approximately 12
inches (30 cm) from auxiliary snatch block (12).
(ac) Spotter must continue to pull passenger side winch cable (23) until winch cable has enough slack that
it touches ground.
(ad) Remove cotter pin (27) and shouldered pin (28) from auxiliary winch cable clevis (29).
(ae) Separate auxiliary winch cable (13) from passenger side winch cable (23).
(af) Lay passenger side winch cable (23) on ground at rear of payload.
(ag) Release AUXILIARY WINCH KICKOUT by lifting and rotating AUXILIARY WINCH KICKOUT lever
(10) CCW.
(ah) Move auxiliary snatch block (12) to payload tiedown shackle (11) at upper left rear recovery eye (16)
of payload.
(ai) Pull auxiliary winch cable (13) forward over platform and along streetside of gooseneck toward
driver's side of winching station on tractor.
(aj) Pull DRIVERS SIDE WINCH lever (34) upward momentarily until there is enough slack in driver's side
winch cable (35) to be removed from stow hook (24).
(ak) Move clevis on driver's side winch cable (35) off stow hook (24) to unstow winch cable.
(al) Continue paying out driver's side winch cable (35) until spotter on ground can reach clevis.
(am) Release DRIVERS SIDE WINCH lever (34).
(an) Remove and retain cotter pin (25) and shouldered pin (26) from clevis on driver's side winch cable
(35).
(ao) Install auxiliary winch cable clevis (29) over one ear of clevis on driver's side winch cable (35) and
install shouldered pin (28) and cotter pin (27).
2-60
|
||
|
||
