Tweet |
Custom Search
|
|
|
||
TB 9-2330-337-14
INSTALLATION (continued)
72. Position right front bracket assembly (30) under fender on vehicle frame and mid-plate (35). Align
bottom of right front bracket assembly (30) flush with bottom of vehicle frame. Clamp bracket in place
on vehicle frame and mid-plate (35).
73. Extend right front bracket assembly (30) to vehicle frame. Align pad of right front bracket assembly (30)
flush with the bottom of the vehicle frame and clamp in place as shown.
74. Using a 19/32 inch drill bit and right front bracket assembly (30) as a template, drill two holes, marked
M, as shown.
75. Remove all burrs and sharp edges. Finish all exposed metal areas using a rust inhibitor primer and paint
as specified in Table 7-4, Materials and Parts. Allow for the appropriate time for primer and paint to cure.
76. Install right front bracket assembly (30) on vehicle frame with four flat washers (6), two hexagon head
capscrews (8), lockwashers (7), and self-locking nuts (5). Hand tighten self- locking nuts.
4-28
|
||