| Tweet |
Custom Search
|
|
|
||
 TB 9-2330-330-14&P-1
INITIAL INSTALLATION (continued)
75. Position rear fender panel (56) on center fender panel (53). Align holes of rear fender panel
(56) with holes in center fender panel (53) and install with four flat washers (3), two capscrews
(9), and two self-locking nuts. Do not fully tighten hardware.
76. Install rear fender panel (56) on two tube canister brackets (55) with eight flat washers (3), four
capscrews (9), and four self-locking nuts (2). Do not fully tighten hardware.
77. Tighten all rear fender panel (56) hardware. Torque capscrews and self-locking nuts
to 55-65 lb-ft (75-88 Nm).
78. Tighten all center fender panel (53) hardware. Torque capscrews and self-locking nuts
to 55-65 lb-ft (75-88 Nm).
79. Tighten all front fender panel (51) hardware. Torque capscrews and self-locking nuts
to 55-65 lb-ft (75-88 Nm).
4-27
|
||
|
||
