Bumper weighs 112 lbs. (51 kg) and may fall if procedures are
not followed carefully. Injury to personnel or damage to equipment
Bumper must be lowered for ALL normal operation.
Bumper is only raised during shipping operations.
1. Remove two pins (1) from bumper (2).
2. Lower bumper (2) until holes in the bumper (2) line up with the holes in the bumper supports (3).
3. Insert two pins (1) through bumper supports (3).
Figure 7. Bumper in the Raised Position
Remove all jacks/stands.
Connect semitrailer to prime mover (if required).
Raise landing legs (if required).
Remove/store tire chocks and ground boards.
Check air pressure for 95 psi (655 kPa).
Ensure proper torque has been applied to flange nuts.
END OF WORK PACKAGE
0016 00-7/8 Blank