BUMPER OPERATION PROCEDURES
Bumper weighs 112 lbs. (51 kg) and may fall if procedures are
not followed carefully. Injury to personnel or damage to equipment
Bumper is only raised during shipping operations.
Center the BII jack or floor jack, if available, under the
Bumper for easier raising and lowering operations. Blocking
or cribbage is required when using the BII jack.
1. Remove two pins (1) from bumper supports (3).
2. Raise bumper (2) until holes are above bumper supports (3).
3. Insert two pins (1) through bumper (2).
4. Lower bumper (2) until pins (1) rest on bumper supports (3).
Figure 6. Bumper in the Lowered Position