SECTION XI. OPERATION UNDER USUAL CONDITIONS
2-98. PREPARE TO OPERATE VEHICLE.
Refer to TM 9-2320-279-10-1 for procedure on preparing to operate vehicle.
2-99. PREPARATION FOR OPERATION-OPERATIONAL MODES.
A complete TFFT crew is required to perform fire fighting
a. Make sure battery switch is in the ON position (TM 9-2320-279-10-1,
para 2-2, Fig. 2-26).
b. Make sure instrument control panel is in standby mode
(para 2-111 & 2-123).
c. Make sure all tanks are full per mission requirement (para 2-110 & 2-122).
d. Make sure all personnel are familiarized with department procedures for
setting wheel chocks (TM 9-2320-279-10-1, para 2-11).
2-100. CREW CAB AIR CONDITIONER/HEATER CONTROL PANEL SET POINT
Air conditioner/heater control panel set points must be
between lower and upper set point limits programmed
during control panel set point parameter programming.
Set point SET2 (air conditioner ON temperature) must
be higher than set point SET1 (heater ON temperature)
for system to operate properly.
a. Put air conditioner/heater control panel switch (1) in ON position.