Quantcast Section III.  OPERATION UNDER USUAL CONDITIONS - TM-10-6640-233-10_68

Custom Search
 
  
 


Section III.  OPERATION UNDER USUAL CONDITIONS ALPHABETICAL INDEX PARAGRAPH TITLE PARAGRAPH Assembly and Preparation for Use  ..................................................................................................................2-7 Laboratory Operating Procedures ....................................................................................................................2-10 Operation of Air and Vacuum Systems ............................................................................................................2-8 Operation of Water System .............................................................................................................................2-9 Preparation for Movement ...............................................................................................................................2-11 Site and Shelter Requirements ........................................................................................................................2-6 2-6.  Site and Shelter Requirements.  Select a site that provides or has the following features: a.  Ample space for maneuvering the vehicles that may be used to move and position a trailer-mounted generator set and the AOAP Mobile Laboratory. b.  Site has a firm, well drained terrain, and is reasonably level. c.  Site is at least 500 feet away from other areas of operation and is not uphill or upstream from other facilities which might be in the path of escaping fuel or vapor. d.  Site is not located adjacent to low areas where dangerous vapors might collect. e.  Site should be- near a stream, a pond, or an established water facility.  This not only provides an outside water source for the AOAP Mobile Laboratory water system, but it also aids in control of potential fires. f.    Site  should  have  easy  access  to  road  nets,  and  at  least  one  road  should  run  in  the  vicinity  of  AOAP  Mobile Laboratory. 2-7. Assembly and Preparation For Use. a.  Inspection.  Inspect the exterior of the laboratory to make sure everything is in good condition. Check the semi-trailer body, doors, near axle assembly and front landing gears to see that they are secure, clean, and correctly  lubricated.    Inspect  the  vents,  water  inlet,  purge  doors  and  the  power  input  panel  for  damage.    If  damage  is found, notify your supervisor.  Refer to TM 9-2330-362-14&P for authorized repair of basic semitrailer van. b.  Initial Setup (Refer to Figure 2-1). NOTE Access   ladders   are   located   in   the   roadside   storage   carriage   labeled   "Tool   Kit/Ladders   and Rails/Storage." 2-27


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc.