| Tweet |
Custom Search
|
|
|
||
 Section VI. REBUILD OF ELECTRICAL SYSTEM
104. Receptacle, Wiring Cable, Terminals, and Connectors
Receptacle pins, receptacle sockets, and terminals are always
soldered to ends of wires or cables. All are replaced in essen-
Refer to TM 9-1825E for disassem-
tially the same manner.
bly, inspection, repair, and assembly procedures for receptacle
and plug-type connectors.
105.
Taillights, Blackout Stoplights, Directional Lights, and
Clearance
Lights
a.
Taillights.
N o t e . The
key
letters
shown
in
parentheses
are
in
(1) R e m o v a l . Refer
to
(2) D i s a s s e m b l y .
Unscrew
six
screws
which
secure
door
assembly (E) and remove door assembly and gasket
(D). Screws are fitted with retainers and will re-
main in door. Remove six round-head screws secur-
ing socket and wiring assembly (B) in body (A). Re-
move socket and wiring assembly, with attached parts,
from body.
(3) C l e a n i n g . Clean exterior of body and door with min-
eral
spirits
paint
thinner
or
dry-cleaning
solvent.
If
necessary to clean interior of body or sockets of socket
and wiring assembly, use clean water and soap solu-
tion
and
dry
thoroughly.
(4) I n s p e c t i o n a n d r e p a i r .
Inspect
door
assembly
(E)
for
cracks, warpage, cracked or broken lenses, or evidence
of leakage around lens gasket.
Note. It is not practical to attempt to replace lenses or lens gas-
kets in door assembly since these are clinched in place to make a
watertight seal.
Inspect body (A) for cracks or evidence of leakage.
Replace
body
if
damaged.
Check
socket
and
wiring
assembly (B) to make sure grommets, sockets, socket
plates, cables, spring, connectors, and cable are in good
condition
and
will
make
good
electrical
and
water-
tight
connections
when
installed.
Pay
particular
at-
tention to triangular grommet at rear of baffle plate
to make sure cables are cemented securely to grom-
met and grommet will make watertight seal in body
Replace defective parts or assembly.
when
installed.
(5) A s s e m b l y .
Position socket and wiring assembly (B)
in body. Place double socket assembly at top of baffle
TAGO 1321B
154
|
||
|
||
