| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-380-14&P
4-92. Loading Procedure (XM1063 Only) (cont'd)
WARNING
Ladder is heavy. Two persons are required to remove/install ladder.
26. Pull out two tension lock pins (1). Hold rear
end of ladder, lower it and aside it forward. Set
ladder aside for later stowage. In interior of van
body.
WARNING
Ladder is heavy. Two persons are required
to remove/install ladder.
27. Pull out two tension lock pins (1). Hold rear
end of ladder, lower it and aside it forward. Set
ladder aside for later stowage. In interior of van
body.
28. Move K-Loader forward, stopping about two
feet from rear landing gear braces.
NOTE
When removing or installing self-locking nuts, one person holds the nut stationary while the other
person turns the screw or bolt.
29. Working as a team, remove nuts (1), washers (2) and screws (3) from center brace (9) of each landing
gear leg. Set braces aside. Reinstall nuts, washers and screws in holes of center brace.
WARNING
Landing leg is heavy. Two persons are required to remove/install landing leg.
30. Working as a team, remove nuts (6), washers (5) and screws (4) attaching mounting
brackets (7) to van body. Separate both landing gears, together with the attached brackets,
from van body. If necessary, turn cranks counterclockwise to raise leg to clear van body.
4-144
|
||
|
||
