Cleaning and inspection - TM-9-2330-380-14-P0149

Custom Search

Back
Rear Relay Valve

Up
TM-9-2330-380-14-P Semitrailer Van: Electronic Tactical 12-Ton 4-Wheel XM1063 (NSN 2330-01-224-9244) and M129A4 (NSN 2330-01-372-5642) Manual

Ratio Relay Valve

TM 9-2330-380-14&P

4-44. Rear Relay Valve (cont'd)

b. Cleaning and inspection

1. Clean mud and dirt from exposed surfaces with water and a stiff brush.

WARNING

Dry cleaning sosolvent (P-D-680) is toxic and flammable. Avoid prolonged breathing of vapors. Avoid

skin contact. Use only in a well-ventilated area. Keep away from open flame. Flash point of solvent

is 138o F (50o C).

2. Remove grease and oil with dry cleaning solvent (item 3, Appendix E). Dry thoroughly.

3. Inspect for loose, missing or damaged parts.

4. Inspect valve, elbows and connectors for cracks, dents, holes and warps. Replace defective parts.

5. Inspect for rust, corrosion and marred paint. Clean, treat, prime and paint as required.

c. Installation

NOTE

Apply teflon tape (item 12, Appendix E) to threads of air line connections before installation.

1. Install nipple (8) at rear of relay valve.

2. Install relay valve (7) to reservoir (2) by turning entire assembly clockwise.

3. Install two elbows (5) and male connector (6).

4. Connect input line (3) to connector (6) and output lines (4) to two elbows (5).

5. Close all drain cocks (1) and pressurize air brake system.

6. Check for leaks (para. 4-43b).

4-71