BLACKOUT LIGHT WIRING HARNESS REMOVAL

Custom Search

Back
TAIL LIGHT WIRING HARNESS INSTALLATION

Up
TM-9-2330-331-14-P Semitrailer Flatbed: Break Bulk/Container Transporter 34 Ton M872A4 (NSN 2330-01-497-0706) (LIN S70159) Manual

REAR CLEARANCE LIGHT WIRING HARNESS REMOVAL

TM 9-2330-331-14&P

0033 00

BLACKOUT LIGHT WIRING HARNESS REPLACEMENT

BLACKOUT LIGHT WIRING HARNESS REMOVAL

1. Remove blackout lights per WP 0029 00-1.

2. Disconnect blackout light wiring harness (1) from rear main wiring harness (2).

3. Remove blackout light wiring harness (1) from frame.

4. Remove and discard damaged grommets as needed.

Figure 6. Blackout Light Wiring Harness

NOTE

See charts in WP 0025 00-3 for details on wiring diagram.

BLACKOUT LIGHT WIRING HARNESS INSTALLATION

1. Install new grommets as needed.

2. Connect blackout light harness (1) to frame.

NOTE

Apply dielectric grease to each plug before connecting to other

cables and harnesses.

3. Connect blackout light wiring harness (1) to rear main wiring harness (2).

4. Install blackout lights per WP 0029 00-2.

5. Connect to prime mover and check all lights for correct operation.

0033 00-7