| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-330-14&P
ENGINE FAN BELT REPLACEMENT--Continued
0110 00
2.
Remove three nuts (4) and lockwashers (5) from outer pulley half (6). Discard lockwashers.
3.
Remover outer pulley half (6) and fan belt (7). Discard fan belt.
INSTALLATION
1.
Install new belt (7), outer pulley half (6), three new lockwashers (5), and nuts (4).
2.
Alternately tighten nuts (4) on outer pulley half (6), while slowly rotating crank shaft pulley bolt (8).
NOTE
After tightening belt per step 2, belt deflection should
be 3/16 (4.8 mm) to 1/4 in. (6.4 mm). If deflection exceeds
1/4 in. (6.4 mm), remove outer pulley half and one shim.
Repeat steps 1 and 2 until proper deflection is achieved.
When installing grille, note that the two short screws fit
in the two lower holes in grille.
0110 00-2
|
||
|
||
