| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-330-14&P
SLACK ADJUSTERS MAINTENANCE--Continued
0069 00
CLEANING AND INSPECTION
NOTE
Do not use solvents or soap and water for cleaning.
1.
Clean slack adjuster, splines of camshaft, and other metal parts using stiff fiber brush, and wipe
clean.
2.
Inspect slack adjuster for bent, broken, loose, or misaligned brake actuator push rods and cracked
or damaged brake actuator brackets. Replace slack adjuster if damaged.
INSTALLATION
1.
Install yoke (2), yoke pin (11), link pin (12), two washers (10 and 13), and new cotter pins (1 and
14) on slack adjuster (6).
2.
Install slack adjuster (6) and new retaining ring (8) on end of camshaft (7).
3.
Install jamnut (4) approximately 1-5/16 in. (3.33 cm) from end of push rod (5).
4
Install yoke adapter (3) on push rod (5) approximately 3/8 in. (9.5 mm) from end of push rod (5).
5.
Turn manual adjustment hex (9) clockwise until yoke adapter (3) extends into bore of yoke (2)
approximately 1/8 inch (3.2 mm). Thread adapter into yoke and tighten to 10 lb-ft (13.6 Nm).
6.
Tighten jamnut (4) to 34 to 50 lb-ft (46.0 to 67.8 Nm).
7.
Lubricate slack adjusters per WP 0044 00.
0069 00-3
|
||
|
||
