| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-330-14&P
HUBS, BRAKEDRUMS, AND ABS SENSOR MAINTENANCE--Continued
0068 00
11.
Install outer bearing nut (6) and tighten to 250 to 400 lb-ft (339 to 542 Nm).
12.
Apply light coat of grease on new gasket (5) and position gasket on hub (11).
13.
Install hubcap (4), six new lockwashers (3), and bolts (2) to hub (11).
14.
Install sensor (17), sensor cable (22), and new grommet (20) through dust shield (25) and axle
flange (24).
NOTE
Coat sensor with grease prior to installation.
15.
Install new sensor clip (18) and sensor (17) to mounting block (19).
16.
Install brakedrum (1) to hub (11).
NOTE
Push sensor through mounting block as far as possible
or until sensor contacts toothed wheel hub.
17.
Secure sensor cable (22) to axle (21) with cable ties (23) as required.
18.
Connect sensor cable to ECU (refer to WP 0070 00).
0068 00-5
|
||
|
||
