| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-330-14&P
BATTERIES, TERMINALS, AND CABLES SERVICE--Continued
0036 00
2.
Inspect battery area for excessive dirt and corrosion. Clean battery area with mixture of baking
soda and water, then flush battery area with clean water (refer to TM 9-6140-200-14).
3.
Check cables (6) for frayed insulation. If insulation is frayed or worn, notify Organizational
maintenance.
4.
Check terminals (5) for looseness. If loose, notify Organizational maintenance.
NOTE
Proceed to step 6 if vehicle is equipped with maintenance-
free batteries.
5.
Remove 12 vent fill caps (7) and check water level. Water level must be just below ring at bottom of
each cell opening. If water level is low, notify Organizational maintenance. Install 12 vent fill
caps (7).
6.
Install battery cover (4), two new self-locking nuts (1), and washers (2) to holddown bracket (3).
END OF TASK
0036 00-2
|
||
|
||
