| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-329-14&P
AXLES REPLACEMENT--Continued
0140 00
INSTALLATION
1.
Using jacks, position axle (5) in place under semitrailer. Raise jacks and rotate axle into position on
ends of both suspension springs (4).
2.
At each end of axle (5), loosely install spring seats (9), two cushioning pads (10), and spring end
cap (11) with two U-bolts (6), eight washers (3), and four nuts (2).
3.
At each end of axle (5), loosely install spring end cap (11) on spring seat (9) on axle (5) with four
screws (1), washers (8), and nuts (7).
4.
Torque eight nuts (2 and 7) evenly to 200 to 320 lb-ft (271 to 434 Nm).
5
Position supports or cribbing under axle (5). Lower and remove jacks.
6.
Using lifting device, raise rear of semitrailer and remove supports or cribbing. Lower semitrailer to
ground.
NOTE
Plug in ABS sensors if necessary (refer to
FOLLOW-ON TASKS
1.
Install air brake chambers (WP 0068 00).
2.
Install slack adjuster (WP 0066 00).
3.
Install hub and brakedrum assemblies (WP 0065 00).
4.
Install wheel assemblies (WP 0007 00).
5.
Disconnect semitrailer grounding cables (WP 0007 00).
END OF TASK
0140 00-3/4 blank
|
||
|
||
