| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-329-14&P
AIR BRAKE CHAMBERS MAINTENANCE--Continued
0068 00
INSTALLATION
1.
Install fittings on air brake chamber (8).
2.
Install air brake chamber (8) on bracket (9) with two nuts (5) and new lockwashers (6).
NOTE
Refer to WP 0066 00 for slack adjuster adjustment.
3.
Install jamnut (3) approximately 1-5/16 in. (3.33 cm) from end of push rod (4).
4.
Install yoke adapter (2) on push rod (4) approximately 3/8 in. (9.5 mm) from end of push rod (4).
5.
Turn manual adjustment hex (11) clockwise until yoke adapter (2) extends into the bore of yoke (1)
approximately 1/8 in. (3.2 mm). Thread adapter into yoke and tighten to 10 lb-ft (13.6 Nm).
6.
Tighten jamnut (3) to 34 to 50 lb-ft (46.0 to 67.8 Nm).
7.
Connect two brake hoses (7) to air brake chamber (8).
TEST
1.
Apply and hold a full-pressure brake application.
NOTE
Initial brake application will force out a small amount
of air. No air should be expelled from air chamber after
initial application. If air continues to be expelled from
air chamber, replace air chamber.
0068 00-3
|
||
|
||
