| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-329-14&P
HUBS, BRAKEDRUMS, AND ABS SENSOR MAINTENANCE--Continued
0065 00
8.
Remove all cable ties (23) from sensor cable (22) along axle (21). Discard ties.
9.
Remove grommet (20), sensor (17), and sensor cable (22) from axle flange (24) and dust shield
(25). Discard grommet.
10.
Remove sensor cable from ECU (refer to WP 0067 00).
CLEANING AND INSPECTION
WARNING
Solvents can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death,
keep away from open fire and use in a well-ventilated area.
If solvent gets on skin or clothing, wash immediately with
soap and water.
CAUTION
Do not clean parts with gasoline, in a hot solution tank,
or with water and alkaline solutions.
Do not use compressed air to spin bearings.
1.
Thoroughly clean all parts with cleaning compound and stiff fiber brush. Make sure parts are
completely dry. Use low-pressure compressed air to dry parts (refer to TM 9-214).
2.
Inspect hubcap for damage to flange that would allow water to leak into wheel bearings. Replace if
damaged.
3.
Check for damage to threads of studs and screws. Replace if damaged.
0065 00-3
|
||
|
||
