| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-329-14&P
GENERAL MAINTENANCE INSTRUCTIONS--Continued
0043 00
WARNING
Compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death,
keep away from open fire and use in a well-ventilated area.
If compound gets on skin or clothing, wash immediately with
soap and water.
Castings, Forgings, and Machined Metal Parts:
Clean inner and outer surfaces with cleaning compound.
Remove grease and accumulated deposits with a scrub brush.
WARNING
Compressed air used for cleaning or drying purposes, or for
clearing restrictions, should never exceed 30 psi (207 kPa).
Wear protective clothing (goggles/shield and gloves) and use
caution to avoid injury to personnel.
3.
Clear out all threaded holes with compressed air to remove dirt and cleaning fluids.
WARNING
Do not wash oil seals, electrical cables, and flexible hoses
with cleaning compounds or mineral spirits. Serious damage
or destruction of material may result.
Oil Seals, Electrical Cables, and Flexible Hoses
Wash electrical cables and flexible hoses with solution of water and soap and wipe dry.
Clean bearings in accordance with TM 9-214.
INSPECTION INSTRUCTIONS
NOTE
All damaged areas should be marked for repair or replacement.
All components and parts must be carefully checked to determine it they are serviceable for reuse, can
be repaired, or must be scrapped.
Inspect drilled and tapped (threaded) holes for the following:
1.
Wear, distortion, cracks, and any other damage in or around holes.
2.
Threaded areas for wear, distortion (stretching), and any evidence of cross-threading.
0043 00-3
|
||
|
||
