| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-326-14&P
3.
Remove four screws (5) and bushing retainer (4).
a. Removal (Cont.).
4.
Remove four screws (11), four lockwashers (12), four washers (13), retainer bushing (15),
bushing bracket (17), two O-rings (16), and retainer bushing (18). Discard lockwashers and O-
rings. Check for worn bushings.
5.
Remove lubrication fitting (14) from retainer bushing (15).
b. Installation.
1.
Install lubrication fitting (14) on retainer bushing (15).
2.
Lube zerk fittings (see page C-4).
3.
Install retainer bushing (18), bushing bracket (17), two new O-rings (16) and retainer bushing
(15) onto S-camshaft (1) with four new lockwashers (12), four washers (13) and four screws
(11).
4.
Install bushing retainer (4) and four screws (5).
5.
Lightly lube S-camshaft lobes with GAA grease. Wipe off excess grease.
6.
Install S-camshaft (1) with washers (2), washers (3), washer (6), spacer (10), and washer (9).
6-20
|
||
|
||
