| Tweet |
Custom Search
|
|
|
||
 TM 9-2330-326-14&P
d. Inspection Instructions.
3. Inspect castings, forgings, and machined metal parts for the following:
a. Machined surfaces for nicks, burrs, raised metal, wear, and other damage
b. Inner and outer surfaces for breaks and cracks.
4. Inspect bearings in accordance with TM 9-214.
e. Repair Instructions.
Any repair procedure peculiar to a specific part or component is covered in the section relating to that
item. After repair, clean all parts thoroughly to prevent dirt, metal chips, or other foreign material from
entering any working parts.
1. Repair casting, forgings, and machined metal parts using the following instructions:
a. Repair minor cracked casting or forgings in accordance with TB 9-2510-242-40.
WARNING
Solvents can burn easily, can give off harmful vapors, and are
harmful to skin and clothing. To avoid injury or death, keep away
from open fire and use in a well-ventilated area. If solvent gets on
skin or clothing, wash immediately with soap and water.
b. Repair minor damage to machined surfaces with a fine mill file or an abrasive cloth dipped in
cleaning solvent.
c. Replace any deeply nicked machined surface that could affect the assembly operation.
d. Repair minor damage to threaded capscrew holes with thread tap of same size to prevent cutting
oversize.
2.
After repair, clean all parts thoroughly to prevent dirt, metal chips, or other foreign material from
entering any working parts.
f.
Tagging Wires and Hoses.
As soon as the first wire, hose, or tube is disconnected, write number "1" on two tags. Secure one tag
to the wire, hose, or tube and the other tag to the terminal, nipple, or fitting. After disconnecting the
second wire, hose, or tube, write number "2" on two tags. Secure one tag to the wire, hose, or tube, and
the second tag to the terminal, nipple, or fitting. Do the same for all wires, hoses, and tubes.
Note which numbers you used, in pencil, on the illustrations in this manual. This will help you to
accurately re-tag, if tags are removed to perform cleaning and maintenance work.
Remove all tags when finished.
6-4
|
||
|
||
