Custom Search
 
  
 


TM 10-6640-239-13 5-33 5-16.    POWER DISTRIBUTION MODULE COMPONENTS. This task consists of: a.    Remove b.   Install INITIAL SET-UP Tools Required General Mechanics Tool Kit, (Appendix B, Section III, Item 2) Materials/Parts Required Lockwashers (23) General Safety Instructions WARNING ELECTRICAL SHOCK Before performing any  maintenance actions on electrical equipment, ensure  all electrical power has been turned off.  Failure to comply with this warning may result in serious injury or death. REMOVE 1. Disassemble Main Power Panel Assembly.  See Figure 5-12. a. Turn off all equipment. b. Shut down generator. c. Disconnect power input cable from generator. d. Disconnect power input cables to Mod Lab A and Mod Lab B. e. Remove 14 screws (1) and washers (2). f. Remove five screws (3), panel assembly (4), and top panel (5) from power distribution module (6). 2. Remove Snap Fasteners. Remove snap fastener (7) by removing screw (8), lockwasher (9), and washer (10).  Discard lockwasher. 3. Remove 3-Phase Current Transformer. a. Tag and remove wires from 3-phase current monitor (11). b. Remove four screws (12), eight washers (13), four lockwashers (14), nuts (15), and 3-phase current monitor (11). Discard lockwashers. 4. Remove splicer block TB1-GND and TB1-NEUT. a. Tag and remove wires from splicer block TB1-GND or TB1-NEUT (16). b. Remove two screws (17), washers (18) and splicer block TB1-GND or TB1-NEUT (16). 5. Remove splicer block TB1-A, TB1-B, and TB1-C. a. Tag and remove wires from splicer block TB1-A, TB1-B, and TB1-C (19). b. Remove four screw (20), washers (21) and splicer block TB1-A, TB1-B, and TB1-C (19).


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business