TM 10-6640-239-13
5-6
5-6.
WATER TANK.
This task consists of:
a. Remove
b. Install
INITIAL SET-UP
Tools Required
General Mechanics Tool Kit, (Appendix B, Section III, Item 1)
Materials/Parts Required
Teflon Tape, (Appendix E, Section II, Item 139)
Flange Gasket, (Appendix E, Section II, Item 50)
Lockwashers (8)
Personnel Required
Two (2)
Equipment Conditions
Water Pump Removed (Paragraph 5-5).
General Safety Instructions
WARNING
ELECTRICAL SHOCK
Before performing any maintenance actions on electrical equipment, ensure all
electrical power has been turned off. Failure to comply with this warning may
result in serious injury or death.
REMOVE
Remove Water Tank. See Figure 5-2.
a.
Open drain valve (1) at bottom of water tank (2). Allow water to drain from tank and system plumbing.
b.
Disconnect three unions (3) and water flow direction valve (4) from top of water tank (2).
c.
Disconnect two unions (5) and switch (6) from top of water tank (2).
d.
Disconnect union (7) at overflow drain line.
e.
Disconnect two unions (8) at water return lines.
f.
Disconnect union (9) on suction line from water pump.
g.
Disconnect drain line union (10).
h.
Remove six screws (11), nuts (12), lockwashers (13), washers (14), and gasket (15) from tee flange (16). Discard
gasket and lockwashers.
i.
Remove two screws (17), nuts (18), lockwashers (19), and washers (20) from each tank support leg (21). Discard
lockwashers.
j.
Disconnect unions and remove any obstructing plumbing as required.
k.
Remove water tank (2).
l.
Remove pipe fittings from water tank (2).
m. Remove drain valve (1) and tee (22) from water tank (2).
|
|